New trinkets for the zed

[Mac Romans]

With having no events to go to this year I’ve scratched my petrolhead itch by having a few bits done.
I’ve gone for a carbon fibre boot lip, carbon fibre splitter and some more colour coded paint inside...

 

[t-tony]

Looking good Mac, how much ground clearance do you have under that front splitter?

Tony.

 

[Shelly]

Really nice
Be careful with the kerbs
I bet your Z looks lovely in the flesh

 

[g8jka]

If I had a Z4 I'd do exactly the same, the spoiler and front lip look amazing. I'd have to get some tyre dressing on them tyres though

 

[Althulas]

Nice subtle additions.

 

[Mac Romans]

Looking good Mac, how much ground clearance do you have under that front splitter?

Tony.

I've not measured it yet but it looks about 90-100mm. The splitter is bolted on, not bonded so it can be removed easily if I need to.

 

[Nodzed]

and some more colour coded paint inside...

What colour?

 

[Mac Romans]

Looking good Mac, how much ground clearance do you have under that front splitter?

Tony.

I’ve now measured the clearance... 95mm. Then I did some research and discovered this:

Bugger!

 

[t-tony]

Like me you’ll need to be careful mate. On a retail park in Lincoln once one the area you cannot leave without going over the “walkway” across the main exit route. I have to go very slowly both onto and off as it catches the soft rubber splitter and the rear ends of the floor/sills area.

Tony.

 

[Toby]

Like me you’ll need to be careful mate.

Tony.

Yep same However you eventually tune out the scraping sound

Seriously though, take care I've found its not always going over the bumps, but when you go down the other side - better to take them at an angle too rather than straight on. If the restriction isn't one going across the full width ( squares type humps ) just take one wheel over helps.

The splitter looks great