Search results

Welcome

Welcome

Welcome

Welcome

welcome

Welcome.

Welcome. A lot of knowledge on here.

All of the internal panel work, consoles etc. all sorted out. They are now ripped back out of the car and foam padding is being glued onto the wood ready for leather. Ran out of spray glue yesterday so progress halted until the new delivery arrives. The sides of the rear bulkhead needed to be...

Cheers Steve I noticed the tiny raised lip behind the old bulkhead and thought a nice short screw would fit in there well. Just ordered a pair of the seat belt guides s you suggested.

A bit more work on the rear bulkhead last night, looks like a bit of boat-building! Needs a lot of fiddling to make sure the roof mechanism does not foul the bulkhead. All good now. I just need to sort the top out, fit the Tonneau fixings and check the fit. Also need to think through the...

As I needed to establish exactly what needs cut back on the centre console, I decided to bolt the seats in place fully and hook up the electrics. With the seats forward a little and raised about 75% the clearance is better for the original Z3 plastic control section (may have to re-fit this...

Welcome

What I did on the 250SWB was make the handbrake section and rear part of the gearlever section only a few inches deep (just enough that the tunnel carpet is not visible with the seat in place (used MGF anniversary seats that time which were a very tight fit). I will try to keep the sides down to...

Gear and handbrake operation are all fine with room to spare, but good thinking in any case. The brackets will be moved to the inside and the joints glued with Tiger Seal once everything is spot on and ready for trimming. It is a lot faster to bracket from the outside whilst everything is in...

2-hours cleaning up the mess in my workshop 2-HOURS!!!!!!! Then 10 minutes chucking the seats in the car to test fit. Of course “Sod’s law” the centre console is too wide at the back so the seats catch grrrrr..... All back out again this week to trim it down a bit and raise the seats to help...

Hi Mike £140 the pair via PayPal collected TN3 9UB or I can arrange courier at cost. (10% of sale price goes to the forum by the way). The red will dye easily with leather dye. They are from a year 2000 2.8 Roadster Let me know.

I also have one in Sussex

If the fault proves to be a dead airbag sensor unit I have one:

Hi folks I have: Oregon Beige Tonneau in perfect condition. I need: The same in Black please If you do not wish to swap and have a Black one for sale let me know. Anyone?

I am only going Red on the seats, door cards (lower section) and the original Z3 Red carpet mats, the rest is black. I will get around to a Swap Ad also