April 2011
So, time to tackle the air bag light with my new Bavarian Dominator B800.
It comes supplied with both the OBDII and round connector for under the bonnet. Tried the ODBII socket under the dash, but it doesn't like that, so on with the adaptor and into the round socket in the engine bay.
Scanning for the fault it came back with...
> Seat belt buckle switch passenger
> Seat occupancy detector, passenger, coding data
Tried a reset, but made no change - same codes. Out with the seat it was then.
With the seat leaning forward so I could access the wiring, I disconnected/reconnected everything.
Plugged the scanner in and it removed the fault for "Seat belt buckle switch passenger", but not both.
Much head scratching, and then went to have a look at the old seat and realised that the new seat didn't have a Seat occupancy sensor installed :head: So I took the one of my old seat and fitted to the M seat.
Plugged the scanner in again, and fault cleared and airbag light now off!
So basically I was a complete numpty, and didn't notice I hadn't plugged all the connectors in when fitting the seat!
Still, the Bavarian Dominator was well worth the £40 in this case.